You do not have a DHCP
server
Static mode - Refer to table: Initialization
procedure
- Obtain from your network
administrator:
• An IP address for the
IP Touch set
• The subnetwork mask
• The router address
• The TFTP server
address, which is the
IP address of the
PowerCPU board
embedding the VoIP
board
Initializing the IP Touch set
To initialize the IP Touch set, refer to the table below.
Note 1:
In each of the two cases below, you can view the IP Touch set's software version after Step 2 by
selecting Version in the Main menu.
table 4.27: Initialization procedure
For an
initialization
that is
Procedure
Dynamic mode
or Proprietary
dynamic mode
1. Connect the power supply.
2. After initialization phase 2 is completed and before phase 5 starts, press i, then
the # key.
The Main menu appears.
3. If the set was previously in static mode, choose IP Parameters from the Main
menu.
The IP Parameters menu appears.
4. Choose Dynamic and press the OK key.
5. Save by pressing the # key.
6. Exit the Main menu by pressing the * key.
Chapter
4
()
4-60
To Next Page
Loading...
