In the procedure below, it is assumed that:
- there is one DHCP server
- no VLAN has to be configured.
Prerequisites
None.
Relocating and retaining the same set
To relocate and retain the same set:
1. Unplug the set.
2. Plug the set into a connector at its new location.
4.5.1.1.3 The Alcatel-Lucent IP Touch 4008 Phone set
The Alcatel-Lucent IP Touch 4008 Phone is a cost reduction of the Alcatel-Lucent IP Touch
4018 Phone with a new transceiver and a new LAN switch.
The Alcatel-Lucent IP Touch 4008 Phone configuration is the same as the Alcatel-Lucent IP
Touch 4018 Phone configuration: both sets share the same profile.
The Alcatel-Lucent IP Touch 4008 phone Extended Edition configuration is the same as the
Alcatel-Lucent IP Touch 4018 Phone configuration.
4.5.1.1.4 Rebooting the set
As of R9.0, to reboot a set:
1. In OMC, go to Users/Base stations List > Details.
2. Click Reset button.
The Reset window opens.
3. Select Reboot and click OK.
4. In the confirmation window, click Yes.
4.5.2 IP Touch 4028/4038/4068 Phone
4.5.2.1 Commissioning
4.5.2.1.1 Overview
This module presents all the actions required for commissioning: .
- The Alcatel-Lucent 8 series:
• Alcatel-Lucent IP Touch 4028 Phone
• Alcatel-Lucent IP Touch 4038 Phone
• Alcatel-Lucent IP Touch 4068 Phone
- The Alcatel-Lucent IP Touch 8 series phone Extended Edition:
• Alcatel-Lucent IP Touch 4028 phone Extended Edition
• Alcatel-Lucent IP Touch 4038 phone Extended Edition
• Alcatel-Lucent IP Touch 4068 phone Extended Edition
Chapter
4
()
4-62
To Next Page
Loading...
Need help?
General
