If Then the required
initialization mode is
And
You have a DHCP server Dynamic mode or
Proprietary dynamic mode
Refer to table: Initialization
procedure
In the case of Proprietary
dynamic mode, the IP address
of the set must be provided by
the Proprietary router.
You do not have a DHCP
server
Static mode - Refer to table: Initialization
procedure
- Obtain from your network
administrator:
• An IP address for the
IP Touch set
• The subnetwork mask
• The router address
• The TFTP server
address, which is the
IP address of the
PowerCPU board
embedding the VoIP
board
Note:
You need to know your set's
directory number.
Initializing the IP Touch set
To initialize the IP Touch set, refer to the table below.
table 4.29: Initialization procedure
For an
initialization
that is
Procedure
Dynamic mode
or Proprietary
dynamic mode
1. Connect the power supply.
2. Before initialization phase 5 starts, press i, then the # key.
The Main menu appears.
3. If the set was previously in static mode, choose IP Parameters from the Main
menu.
The IP Parameters menu appears.
4. Choose Dynamic.
5. Save by pressing the soft key in the upper left part of the display.
6. Exit the Main menu by pressing the soft key in the upper right part of the display.
()
4-65
To Next Page
Loading...
Need help?
General
