The 3.5 mm female jack can receive an external station speaker jack.
In order to take the external station speaker into account, the set customization for the jack
has to be set to “Loudspeaker”.
Prerequisites
None.
Connecting an external station speaker
To connect an external station speaker, plug the external station speaker jack into the
associated connector on the side of the set.
Programming keys
This section describes how to program a programmable key from the:
- F1/F2 keys
- Add-On Module keys (if any)
- virtual add-on keys
Two methods are presented.
Programming a key
To program a key:
1. From the MENU tab, select Settings.
The Settings menu appears.
2. From the Settings menu, select Keys.
The virtual add-on keys appear.
3. Select the key to be programmed, as follows:
• To program a virtual add-on key, scroll using the up/down navigator keys until you
reach the required virtual key and then press the corresponding soft key.
• To program the F1 or F2 key, or a key on a connected Add-On Module, simply press
this key.
4. Select Name and enter the name to be associated with the selected key, then press OK.
The desired name is associated with the key.
5. Select Number and enter the telephone number to be associated with the key, then press
OK.
The desired number is associated with the key.
6. Press Exit to go back to home page.
Programming a key (fast customization)
You can also program a key using the following method:
1. Select the key to be programmed, as follows:
• To program a virtual add-on key, from the PERSO tab press i followed by the required
key.
• To program the F1 or F2 key, or a key on a connected Add-On Module, from any tab
press i followed by the required key.
Chapter
4
()
4-68
To Next Page
Loading...
Need help?
General
