Getting to know your telephone
Next generation of Bluetooth® handsets (ALE Wideband Bluetooth®
Handset)
The Bluetooth® Wireless handset is only available with compatible Bluetooth® desk phones.
ALE Wideband Bluetooth® Handset
LED (front and back of the device)
• LED off: the handset is charging on its base or is switched off. When you put the handset on its
base, the LED turns blue briefly and turns off again when the battery starts to charge.
• Blue flashing: normal operation.
• Red slow flashing: battery charge low. If voice prompts are enabled, you hear: Battery low
• Red fast flashing: handset outside coverage zone. If voice prompts are enabled, you hear: Out
of Range
• Red steady: handset not paired.
Line key
• Switch the device on/off: press and hold to switch the device on/off. If voice prompts are
enabled, you hear: Power On / Power Off.
• Off-hook/On-hook: press this key to take or terminate a call.
• Voice prompts (in idle state): double press to enable the voice prompt.
Volume/Mute key
• Volume (during conversation): press in quick succession to change the handset volume level.
• Mute (during conversation): press and hold to ensure your correspondent no longer hears you.
• Voice prompts (in idle state): double press to disable the voice prompt.
• Location of the battery.
If the Bluetooth® handset is on its base, you do not need to press the Off-hook/On-hook key to take or
terminate the call. Just off-hook/on-hook the Bluetooth® handset
The battery recharges when the Bluetooth® handset is on its base. When you put the handset on its
base, the LED turns on briefly and turns off again when the battery starts to charge. The battery
autonomy is more than 10 hours in conversation, and 50 hours in idle state. Charge the battery for
about 6 hours before initial use.
To Next Page
Loading...
