Phone auto test
The auto test of the phone is a quick hardware test of the sound, the display and the LEDs. It lets the
user do the first tests directly from the desktop.
• The phone is switched on and connected.
• Reach the 'Menu' page.
• Settings Options Phone test
• Auto test has started.
• To stop the auto test.
Access to administrator configuration
Your administrator can access to the phone configuration. Depending on the system configuration, an
administrator password is requested to access this menu.
• Start your desk phone by connecting it to the network (and plugging in the power jack if you are
using an external power adapter).
• When the desk phone displays the 'Step 2' during the boot, repeatedly press the '*' and '#' keys in
succession until a menu is displayed.
• This section allows the administrator to set or consult:
o IP parameters: IP Parameters IP Status
o DHCP option: IP Parameters IP Config
o Phone memory: IP Parameters Memories
o Used network (wired or wireless): Network
o Wired network configuration: Network Wired network
o Wireless network configuration: Network Wireless network
o VPN configuration: VPN
o Security: Security
o Software information (version, run mode): Software infos
o Hardware information (MAC, CPU): Hardware infos
o Beacon activation: Hardware info Bluetooth info Beacon: Enable Beacon
o Software update mode: Software infos Upgrade
▪ Enable software upgrade: upgrade via network (system).
▪ Upgrade from USB now: use a USB drive to upgrade the software when you
restart the desk phone.
o Network default parameters (reset configuration): Network Set default
o Factory configuration: Reset to Defaults
To Next Page
Loading...
