WHITEIdle / Standby
BLUE Badge ID sent
GREENAccess Granted
Info Bar
Status Bar
Main
Display
18Ver. 1.01
OLED Display
How is a successful install confirmed?
Out of the Box Settings
Pre-Requisites
The Rock OLED Display contains 3 sections:
■ Status bar: displays icons that require attention
■ Main: authentication guidance icons
■ Info: informational such as the Rock’s IP and Network settings will scroll across
A successful installation of the Rock on the wall is confirmed by carrying out this quick test.
A test pass confirms:
■ Reader and ACS are correctly wired to the Rock
■ Auto-enrollment is successful
■ 1FA authentication is successful
The Rock is not required to be connected to the network to perform the test.
Out of the box, the Rock
■ Is in Demo Mode and will authenticate in Single Factor (1FA)
■ Auto-Enrollment is enabled requiring two badge-ins separated in time by just a few seconds
■ Enrollments are deleted by a power cycle
1. Before proceeding with the test
■ ensure that you have a valid badge that is enrolled in the ACS to be granted access through the door
■ or have someone on site with a valid badge and will be granted access through the door
2. Remove the Protective film protecting the Rock’s screen and sensors
To Next Page
Loading...
