23Ver. 1.01
Once the end-to-end installation test successfully completes, the physical installation of the Rock is finished.
1. The Rock is wired correctly to the Reader and ACS
2. Auto-enrollment has been confirmed
3. Authentication has been confirmed
The next part of the process is to configure the Rock for normal operations.
This part requires:
4. The Rock’s Device ID
5. The Alcatraz Admin Portal username and password
6. The customer specific mode of operation ex. 1FA or 2FA
Follow these steps to configure each Rock.
Step 1 – Configuring Network Settings
Step 2 – Onboarding a Rock
Step 3 – Configuring the Rock Mode
Step 4 – Configuring the Card Format
After carrying out the steps for each Rock, the Rock is ready for normal operations.
To Next Page
Loading...
