© Honeywell LT-MS4IOG Rev. 04 | Revised October 2015
37
INSTALLATION & OPERATIONS GUIDE | MICROSET 4
To adjust values of variables within each mode (Field Service, Balance, Custom Codes, and
Settings)
1. Press the Field Service, Balance, Custom Codes, or Settings button on the screen.
(Balance button not available in MS4-TH-MSTP model.)
2. Press the
LEFT/RIGHT navigation arrow until the variable you want to adjust appears.
3. Press the
UP/DOWN arrow on the screen to adjust the setting.
4. Press the
LEFT/RIGHT navigation arrow to accept your change and scroll to a different
variable.
To exit configuration mode
• Press the
LEFT and RIGHT navigation arrows simultaneously.
• After 45 minutes of inactivity, Service mode will exit automatically.
To Next Page
Loading...
