38
change a characters case (lowercase or UPPERCASE);
5. Press the NAME button again when finished.
Note: If the UP/DOWN buttons are pressed while the NAME button
is held down, you can scroll through a default set of 16 pre-stored,
generic names (such as “Verse A1”, “Chorus 2”, “Bridge”, etc.).
You can edit these names, so that they represent the names you
wish to use, such as “TurnArnd”, etc. These names are saved
whenever you save a setup to tape (see section 5.2A) or via MIDI
system-exclusive (see section 5.3B).
To edit the pre-stored names:
1. Hold the NAME button and use the UP/DOWN buttons to select
the pre-stored name you wish to edit (Important: You
must
scroll
through the list to enter “pre-stored name editing” mode, even if
the name you wish to edit is already displayed);
2. Use the Numeric Keypad and Cursor buttons to alter the
characters of the pre-stored name (see above);
3. Hold down the NAME button and press the RECORD button to
store the new name into the pre-stored name list;
4. To check that the new name was stored, hold the NAME button
and use the UP/DOWN buttons to scroll through the list of pre-
stored names to find the name you changed. If you can’t find the
name in the pre-stored name list, repeat steps 1–3 above.
4.1E Locating a Locate Point
The LOCATE button is used to rewind or fast forward the tapes to a
pre-stored locate point or a manually input location (see section 4.1F).
To locate to a locate point:
1. If the LCD display is not currently displaying the locate page, press
the LOCATE button;
The display reads as follows:
L
X
X "LocNamXX"
hh:mm:ss:ff
…where XX is the locate number (00, 01 through 20, 21-22),
LocNamXX is an 8-character name and hh:mm:ss:ff is the locate
To Next Page
Loading...
