Do you have a question about the Alesis BRC and is the answer not in the manual?
Brand | Alesis |
---|---|
Model | BRC |
Category | Recording Equipment |
Language | English |
Detailed steps for connecting ADATs via sync cables for system integration.
Steps to connect ADATs using fiber optic cables for digital audio transfer.
Process of formatting ADAT tapes for time-stamping and synchronization.
Important points to consider during tape formatting procedures.
Controls for selecting tracks for recording and monitoring.
How to enter record mode and start recording.
Adjusting tape speed to control pitch across all connected ADATs.
Setting and recalling specific tape locations for easy access.
Storing the current tape position as a named locate point.
Editing names for stored locate points.
Navigating the tape to a previously stored locate point.
Creating continuous playback or record loops between points.
Defining start and end points for looping.
Combining Loop and Auto-Play for continuous looping.
Automating punch-in and punch-out operations.
Defining punch-in and punch-out locations.
Recording multiple takes across groups of tracks automatically.
Setting pre-roll and post-roll times for locate and loop functions.
Adjusting tape position offsets between ADAT machines.
Specifying offset amounts for individual ADAT units.
Staggering ADATs for infinite continuous recording or playback.
Routing digital audio for track copying and AES/EBU or S/PDIF I/O.
Selecting the type of digital input source (ADAT, AES/EBU, S/PDIF).
Copying tracks between ADATs via the digital bus.
Selecting external sources for synchronization (Locate Reference, Clock Source).
Setting tempo and time signature for songs, including changes.
Defining tempo and time signature changes at specific bar numbers.
Saving and loading BRC setup information (TOC) to tape or MIDI.
Saving BRC configuration as a table of contents (TOC) onto tape.
Loading BRC configuration from tape into internal memory.
A guide to common problems and their solutions.