39
point’s address. The address is displayed according to the type of
Display Type you have selected. If in NORMAL mode, the display
will read 00:00:00 (minutes:seconds:frames). If in SMPTE mode, the
display will read 00:00:00:00 (hours:minutes:seconds:frames); if in
BARS mode, the display will read 01–01/00 (bars:beats:sub-beats).
2. Use the UP/DOWN buttons to select a locate number (01-20), or
either of the Auto-punch in/out locations (21 & 22). The name
and address will be updated as you scroll through the stored locate
points;
3. The location address for the currently displayed locate point can be
edited before initiating the locate by selecting the desired field with
the Cursor buttons and changing the value with the Numeric
Keypad, UP/DOWN buttons, or the COPY TAPE LOCATION
button;
Note: To use the COPY TAPE LOCATION button, it must be set to
Normal mode in the MIDI/UTIL section (see section 5.3F).
When editing the location address, the cursor will automatically
advance to the next field until the last digit of the frames field. Only
locate point names 01 through 20 may be edited. The Manual locate
point (00) and Auto-Punch points (21 & 22) have names which
cannot be edited.
4. As shown in SETTING A LOCATE POINT (see section 4.1C), a
second page can be accessed by pressing the Right Cursor button
past the frames field, where you can fine tune the locate point by
adjusting its position in sub-frames and samples;
5. While the LCD display is currently displaying the Locate page,
press the LOCATE button again to rewind or fast forward to the
currently displayed location address.
Either the REWIND or FAST FORWARD button will flash,
depending on the direction of the search.
4.1F Manual Locate
Sometimes you may want to locate to an arbitrary tape position
which hasn’t been stored into a locate point. To do this:
1. Press LOCATE button;
2. Use the Numeric Keypad or the DOWN button to select
location 00;
To Next Page
Loading...
