64
5. Press the DIGITAL I/O button to enable the digital bus (the
DIGITAL I/O button LED will go on to indicate it is enabled).
4.7B Bouncing tracks
The BRC makes it possible to copy tracks between ADATs without
leaving the digital domain. The BRC assumes you have connected
the digital bus correctly between all ADATs in the system (see section
2.2A).
If DIGITAL I/O is pressed again when the digital input display reads
"ADAT", you may select which track(s) will be routed to the digital
bus, and thereby sent to any tracks that are in record when DIGITAL
I/O is enabled. This allows for digital track copying and backups.
To digitally bounce tracks:
1. Press the EDIT button (the EDIT button LED will go on to indicate
you are in Edit mode);
2. Press the DIGITAL I/O button;
The display will read:
Digital input:
A
DAT
3. Press the DIGITAL I/O button again while the digital input display
reads “ADAT”;
The display will show the following:
Select source with
trk buttons
All the record and input track LEDs will turn off, as they no longer
reflect the record/monitor status. The TRACK INPUT LEDs are now
used to reflect the current source tracks.
4. Use the TRACK SELECT buttons to choose the source tracks (that
is, the tracks to be assigned to the digital bus);
• If you select a track to be a source that was previously put into
record-enable, it will automatically be taken out of record-enable.
Once a track has been selected as a source, it cannot be put into
record-enable while the DIGITAL I/O button is turned on.
To Next Page
Loading...
