49
• Tracks 5 and 6 record LEDs will be solid, while the LEDs of other
record-enabled tracks will be flashing.
4th loop pass:
• Auto-punch in and out occurs on track 7 and 8;
• Tracks 7 and 8 record LEDs will be solid, while the LEDs of other
record-enabled tracks will be flashing.
5th loop pass:
• No punch in occurs on any tracks;
• The LEDs of all record-enabled tracks will be flashing.
Example 2:
If channels 1,2,5,9,13,16 are record-enabled and the record group size is
4, then the following will occur:
1st loop pass:
• Auto-punch in and out occurs on tracks 1, 2, 5 and 9;
• Tracks 1,2,5,9 record LEDs will be solid, while the LEDs of the other
record-enabled tracks will be flashing.
2nd loop pass:
• Auto-punch in and out occurs on tracks 13 and 16;
• Tracks 13 and 16 record LEDs will be solid, while the LEDs of the
other record-enabled tracks will be flashing.
3rd loop pass:
• No punch in occurs on any tracks;
• The LEDs of all record-enabled tracks will be flashing.
Note: If the looping process is interrupted (by pressing STOP, or
locating a cue point, etc.), the record group counter will be reset.
This means that if you re-enter record, the first group will enter
record again. If you stop Auto-Group Record and wish to continue
from where you left off, turn off the record-enables for the tracks
you’ve already recorded.
Note: Auto-Group Record is always enabled. When it is set to ALL,
this is the same as normal Auto-Punch recording.
Note: If the AUTO INPUT button is off, all record-enabled channels
will always be in input monitor. If AUTO INPUT is on, then only
the channels that are actually recording (record LED solid) will be
in input monitor mode, while all other channels will be
monitoring tape (see section 3.2C).
4.3C Footswitch Controlled Punching
To Next Page
Loading...
