Alesis BRC - Tape Offset

51
a point beyond the locate point by the amount you specified, before
rewinding.
Both the Pre-Roll and Post-Roll times are set in the identical manner.
To display and/or edit the Pre-Roll or Post-Roll Time:
1. Press the EDIT button (the EDIT button LED will go on to indicate
you are in Edit mode);
2. Press either the PRE-ROLL or POST-ROLL button;
The display will show the Pre-Roll Time:
Pre-Roll Time xx.x
seconds
…or the Post-Roll Time:
Post-Roll Time
xx.x seconds
…where XX.X is a value between 0.0 and 20.0 seconds. The default
value is 5.0 seconds.
3. Use the UP/DOWN buttons to select a value between 0.0 and 20.0.
• Selecting a non-zero Pre-Roll Time will cause the tape to locate to
a point within seconds before the normal locate point. Setting a 0
Pre-Roll Time will cause the tape to locate to the exact position of
a locate point (this is the same as disabling Pre-Roll).
• Selecting a non-zero Post-Roll Time will cause the tape to rewind
at a point within seconds after the normal loop end point. Setting
a 0 Post-Roll time will cause the tape to rewind at the exact
position of the loop end point (the same as disabling Post-Roll).
Note: Both the Pre-Roll and Post-Roll Times affect the Loop function
(see section 4.2).
4.5 TAPE OFFSET
The TAPE OFFSET button is used to enable and disable the stored
offsets between ADAT machines. Each slave ADAT can have its own
offset. When the TAPE OFFSET button is pressed, its LED is lit to
indicate that the stored offsets are in effect. These offsets are not