88
External Sync: SMPTE (all formats), Video (composite
or black-burst), and 48 KHz word clock
General
Front Panel Controls and
Indicators: Illuminating transport controls for
Play, Stop, Fast Forward, Rewind, and
Record. Numeric keypad (0-9, Up and
Down). Record Enable push buttons
and LED indicators for tracks 1–32.
Push buttons for track banks 1–32, 33–
64, 65–96, and 97–128. Push buttons for
Set Group, All Clear, Pitch Mode, Pitch
Up (+100 cents), Pitch Down (-300
cents), MIDI/Util, Tempo Map, Record
Xfade, Save Setup To Tape, Load Setup
From Tape, Set Song, Locate Song,
Copy Song, Delete Song, Locate, Set
Locate, Locate 0, Name, Cursor < and
>, Display Type, Display Mode, SMPTE,
SMPTE Start Offset, Reset 0 and Eject.
Push buttons with LED indicators for
Auto Input, All Safe, All Input,
Groups 1–4, Format, Ext Sync, Auto
Punch, Pre-Roll, Post-Roll, Loop, Tape
Offset, Track Delay, Digital I/O, Gen
Sync, Edit, Auto Play and Rehearse. 7
segment LED display indicates pitch
change. 7 segment LED display
indicates tape position (Normal time,
SMPTE, or Bars). 32 character LCD
display. LED indicators for Pitch Mode
(Fixed, Variable), MIDI In, SMPTE In,
Display Type, Display Mode and
SMPTE Format.
Rear Panel Controls and
Connectors: One 9 pin D-Sub connector for Sync
Out. Four 1/4" phone jacks for LRC
Remote Controller and for Punch
In/Out and Locate/Play footswitches,
SMPTE In and SMPTE Out (+4, -10 dB).
Two MIDI connectors for MIDI In and
MIDI Out. Three BNC connectors for
48 KHz In, 48 KHz out and Video In.
AC power switch and IEC-spec AC cord
connector.
Power Requirements: 90-250 VAC, 50–60 Hz, 50 W max.
To Next Page
Loading...
