8138 SIP Multicolor Strobe Light
Basic Settings Tab – Multicast
Multicast IP Addresses
Each 8138 SIP Strobe Light has its own IP address, and shares common multicast IP and
port numbers (multicast zone) for multicast packets. The master device transmits to a
configurable multicast zone, and the slave units listen to all the multicast zones assigned
to them.
The network switches and router see the packet and deliver it to all the members of the
group. The multicast IP and port number must be the same on all the master and slave
units of one group. The user may define multiple zones by picking different multicast IP
addresses and/or port numbers.
1. Multicast IP addresses range: 224.0.0.0/4 (from 224.0.0.0 to 239.255.255.255)
2. Port numbers range: 1 to 65535
3. By default, the 8138 SIP Strobe Light is set to use the multicast IP address
224.0.2.60 and the port numbers 50000-50008
Make sure that the multicast IP address and port number do not conflict with other
services and devices on the same network.
Multicast Page Zones
The 8138 SIP Strobe Light supports nine “basic” multicast zones. These zones are
defined by the multicast IP addresses.
Somewhat arbitrarily, these zones are defined below but may be used in other ways. The
important consideration is that there is a priority hierarchy – streaming activity on a zone
higher on the list, will be treated as a higher priority than a zone lower on the list – with
music being the lowest priority.
1. Priority
2. All Call
3. Zone 1
4. Zone 2
5. Zone 3
6. Zone 4
7. Zone 5
8. Zone 6
9. Music
“Expanded” zones can also be enabled, in the Basic Settings > Multicast tab, allowing
up to 50 zones in total. These have the same behaviors as the basic zones, but are
hidden by default to simplify the interface.
Document 90-00102C
11/27/2019
Page 23
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
(604) 454-3792
support@algosolutions.com
To Next Page
Loading...
