8138 SIP Multicolor Strobe Light
Multicast Type – Polycom Group Paging/Push-to-Talk
The 8138 may receive multicast paging compatible with Polycom “on premise group
paging” protocol.
To configure the 8138 as a slave to receive Polycom page announcements, select “Group
Page” or “Push-to-Talk”. Then enter the Polycom Zone (IP Address and Port) that
matches the configuration of the Polycom phones and Channels. The “Default Channel” is
the target group in a Polycom paging environment.
Number of Zones
Select ‘basic’ zones if configuring nine or fewer multicast zones or ‘expanded’ to configure
up to 50 zones. The expanded zones have the same behavior as the basic Slave zones,
but are hidden by default to simplify the interface.
Slave Zones
Select one or more multicast zones for the 8138 SIP Strobe Light to monitor. Note that
multicast zone priority is based on the zone definition list order (top to bottom).
Document 90-00102C
11/27/2019
Page 26
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
(604) 454-3792
support@algosolutions.com
To Next Page
