8138 SIP Multicolor Strobe Light
VLAN Mode
Enables or Disables VLAN Tagging. VLAN Tagging is the networking standard that
supports Virtual LANs (VLANs) on an Ethernet network. The standard defines a system of
VLAN tagging for Ethernet frames and the accompanying procedures to be used by
bridges and switches in handling such frames. The standard also provides provisions for a
quality of service prioritization scheme commonly known as IEEE 802.1p and defines the
Generic Attribute Registration Protocol.
VLAN ID
Specifies the VLAN to which the Ethernet frame belongs. A 12-bit field specifying the
VLAN to which the Ethernet frame belongs. The hexadecimal values of 0x000 and 0xFFF
are reserved. All other values may be used as VLAN identifiers, allowing up to 4094
VLANs. The reserved value 0x000 indicates that the frame does not belong to any VLAN;
in this case, the 802.1Q tag specifies only a priority and is referred to as a priority tag. On
bridges, VLAN 1 (the default VLAN ID) is often reserved for a management VLAN; this is
vendor specific.
VLAN Priority
Sets the frame priority level. Otherwise known as Priority Code Point (PCP), VLAN Priority
is a 3-bit field which refers to the IEEE 802.1p priority. It indicates the frame priority level.
Values are from 0 (lowest) to 7 (highest).
802.1x Authentication
Credentials to access LAN or WLAN that have 802.1X network access control (NAC)
enabled. This information will be available from the IT Administrator.
Differentiated Services (6-bit DSCP value)
Provides quality of service if the DSCP protocol is supported on your network. Can be
specified independently for SIP control packets versus RTP audio packets.
DNS Caching Mode
In "SIP" mode, only the results of DNS queries for SIP requests will be cached. In "All"
mode, the results of all DNS queries will be cached.
Document 90-00102C
11/27/2019
Page 34
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
(604) 454-3792
support@algosolutions.com
To Next Page
