10
Version 1.01
WEEE Directive
Risks associated with operations to Read or Reprogram data
When reading or programming data via KESSv2, if the communication between the tool and the
electronic control unit were to be interrupted problems may occur, also of serious entity and
which may extend to the complete failure of the ECU itself, with consequent need for its
replacement.
Therefore, during these operations:
DO NOT disconnect the communication cable between the tool and the vehicle.
DO NOT unplug the USB cable between the tool and the computer.
DO NOT turn off your computer.
DO NOT use the tool in a location that is exposed to static electricity or electrical interference.
If, for any reason, a damage to the ECU or a data loss or corruption (even partial) occurs and it is
not possible to make a recovery, Alientech Srl, its subsidiaries and affiliates will not be will not
be held liable for any damages, costs or expenses coming from this loss or corruption.
Cleaning
Cleaning the exterior surface: Wipe gently with a soft cloth. Do not use solvents or other
chemicals to clear the exterior surface of the KESSv2.
Cleaning the connectors: Do not use the product if the connectors are not clean. Remove the
dirt with a dry cloth.
This symbol on the product or its packaging indicates that this product shall not be
treated as household waste. In line with EU Directive 2002/96/EC for waste of electrical
and electronic equipment (WEEE), this product must not be disposed of as unsorted
municipal waste. Please dispose of this product by returning it to the point of sale or to
your local municipal collection point for recycling.
To Next Page
Loading...