19
Version 1.01
FAM: The number of the Family to use to communicate with the vehicle.
CHK: The check mark indicates that the Checksum control is available. Checksum control is
available for all OBDII and Tricore Families of KESSv2. For ST10Fxxx Families, the Checksum is
available if the writing is performed via OBDII; if, instead, the programming is done on bench
you should check the Checksum in another way.
RD: The check mark indicates whether the ECU supports the reading. If the box is white
(empty) it is not possible to read the ECU through the diagnostic connector of the vehicle.
Refer to the section File Management (page 28) for more details.
Writing is always available for all families, so there is no dedicated column in the vehicle list.
It is possible to consult the list of vehicles supported by KESSv2 at any time, even if the tool is
not connected to your computer and / or the computer does have an active Internet
connection.
To Next Page
Loading...