Alienware Command Center (AWCC) │ 20
5. Switch the DPI and polling rate by pressing the Preset button.
6. Configure the polling rate.
To configure up to 8KHz in wired mode.
a. Connect the cable to the mouse.
b. Change the polling rate of every DPI stage from the Polling Rate
drop-down list at the bottom of each DPI level slider.
c. Switch the DPI and polling rate by pressing the Preset button.
To configure up to 4KHZ in wireless mode.
a. Connect the dongle to the mouse.
b. Change the polling rate of every DPI stage from the Polling Rate
drop-down list at the bottom of each DPI level slider.
c. Switch the DPI and polling rate by pressing the Preset button..
NOTE: 1. The default polling rate is 1000 Hz. The maximum polling rates of
each connectivity are as follows:
a. Wired mode: 8000 Hz
b. Wireless mode: 4000 Hz
Alienware Command Center (AWCC)
To Next Page
Loading...
