Allen-Bradley 1734-SSI - Chapter 2 Configure the Module; Add the Adapter to Your Network

Rockwell Automation Publication 1734-UM007E-EN-P - October 2015 15
Chapter 2
Configure the Module
About This Chapter
Read this chapter for information about how to use RSNetWorx for DeviceNet
software to configure your module. You can configure the module while it is
online or offline.
This chapter shows configuration in the online mode. Configuration dialogs
appear similar in both modes. The primary difference is that if you make changes
offline, you must go online before the configuration changes take effect.
Add the Adapter to Your
Network
To add the adapter to your network, follow these steps.
1. Start the RSNetWorx for DeviceNet software.
2. Add the communication device as shown, noting that in this case, the
chosen device was a 1734-ADN DeviceNet adapter.
1. Click the “+” here to expand the
list of communication adapters.
2. Double-click the 1734-ADN
DeviceNet adapter. (You can also
click and drag the adapter name
onto the network.)
The scanner appears on the network.