Rockwell Automation Publication 1734-UM007E-EN-P - October 2015 17
Configure the Module Chapter 2
Set the Encoder’s Parameters
After adding the module to the network, you must configure the module for use.
1. Configure the modules as shown in the figure.
You see a dialog with a series of tabs. Each tab provides options to view or
edit.
This chapter shows configuration in the online mode. Changes set in this mode
take effect when you download to the individual module.
1. Click the module to highlight it.
2. From the Device menu, choose
Properties. (You can also right-
click the module or name, and the
property dialog pops up.)
These are the tabs you click
to view the options.
To Next Page
Loading...
