2. Refer to the dialogs for an explanation of features.
Use this menu to edit or view
the parameters.
Available choices are:
The module’s name appears here.
Type a description here.
The module’s address appears here.
(This field is read only.)
This dialog also shows the
module’s device identity.
These fields are read only.
Click the Device parameters tab
to get to the dialog for setting
the parameters.
At any point, you can click here to finish
changing configuration parameters.
If configuration changes are made in
offline mode, they do not take effect until
the system goes online.
This dialog appears after you click the Device
parameters tab. If you want the existing
parameters uploaded from the module, click
Upload. The following dialog then shows the
existing parameters set on the module.
Parameters tab
Configuration tab
To Next Page
Loading...
