Allen-Bradley 1734-SSI - Work with the Feedback Dialog

Rockwell Automation Publication 1734-UM007E-EN-P - October 2015 39
Configure Modules in RSLogix 5000 Software Appendix A
Work with the Feedback
Dialog
Follow these procedures to complete entries for the Feedback dialog.
1. From the General dialog, click Feedback to display the Feedback dialog.
2. From the Feedback dialog, complete entries, referring to the table.
3. From the Feedback dialog, complete one of these.
• Click OK to save changes and close the dialog.
or
• Click Cancel to return to default values.
or
• Click Apply to save changes you made on any of the dialogs and
continue to display the dialog, noting that you enable the Apply button
when you make changes to any of the dialogs.
or
• Click another tab at the top of dialog.
For more information on these parameters, refer to the definitions in Chapter 4
of this publication.
For Select Comments
Code Type Binary or Gray Default is Gray.
Word Length 2...31 Default is 13.
Data Speed 125 Kbps
250 Kbps
500 Kbps
1 MBps
2 MBps
Default is 125 Kbps.
SSI Word Delay Time 16...65535 Default is 64 μs.
SSI Word Filter Control Max
High
Med
Low
Off
Default is Max.
SSI Clock On or Off Select On or Off to select the SSI clock.