42 Rockwell Automation Publication 1734-UM007E-EN-P - October 2015
Appendix A Configure Modules in RSLogix 5000 Software
Work with the Watch
Position Dialog
Follow these procedures to complete the entries for the Watch Position dialog,
referring to the Comparators 1 and 2 section of the Set and Operate Your
Module chapter for a description of:
• Comparator Control and Comparator Value
• Manual and Automatic Mode
1. From the General dialog, click Watch Position to display the Watch
Position dialog with the Not Active default for Comparator Control
0 and 1.
2. From the Watch Position dialog, make entries for Automatic or Manual
mode, referring to the table and noting the following.
• For Automatic mode for Comparator Control 0 and 1, leave the value
as Not Active and complete the entries for Comparator Value 0 and 1.
To Next Page
Loading...
