Rockwell Automation Publication 1734-UM007E-EN-P - October 2015 19
Configure the Module Chapter 2
Check I/O Status and View
the EDS File
You can view the I/O defaults setup, and the EDS file by clicking the appropriate
tab.
To configure your module,
select Configuration and
modify the parameters as
desired for your application.
Click OK when finished.
Click the I/O Data tab to display
the default characteristics for this
module.
This dialog shows the input/output
defaults for the three modes.
These are:
• Polled
• Change of state
• Cyclic
To Next Page
Loading...
