Publication 1746-UM022B-EN-P - January 2005
2-6 Installing And Wiring Your Module
4. Cover all unused slots with the Card Slot Filler, Allen-Bradley
part number 1746-N2.
Terminal Block Removal
To remove the terminal block:
1. Loosen the two terminal block release screws. To avoid cracking
the terminal block, alternate between screws as you remove
them.
2. Using a screwdriver or needle-nose pliers, carefully pry the
terminal block loose. When removing or installing the terminal
block be careful not to damage the CJC sensors.
To Next Page
Loading...
