Rockwell Automation Publication 2100-IN012G-EN-P - August 2016 123
Bulletin 140G Unit Assembly Instructions Appendix A
11. Attach the handle assembly to the base plate by using #10-32 x 0.38 hex
head thread-forming screws and tighten to 24…40 lb•in
(2.7…4.5 N•m).
12. With the handle in the ‘OFF’ position, align the tab on the bale with the
slot in the mounting plate and secure with a #10-32 x 0.38 hex head
thread-forming screw.
13. With the handle and the circuit breaker in the ‘OFF’ position, engage
the linkage to the notch in the bale.
14. Attach the external auxiliary contacts to the bracket.
Handle Linkage
Stud
Notch in bale
Handle
Assembly
#10-32 x 0.38 hex head
24…40 lb•in (2.7…4.5 N•m)
Handle Linkage
Stud
Notch in bale
Tab on bale
Slot on
Mounting Plate
To Next Page
Loading...
