Rockwell Automation Publication 20C-PM001F-EN-P - March 2012 41
Programming and Parameters Chapter 2
UTILITY
Diagnostics
227 [Status 1 @ Fault]
Captures and displays [Drive Status 1] bit pattern at the time of
the last fault.
1 = Condition True
0 = Condition False
Read Only 209
224
thru
230
228 [Status 2 @ Fault]
Captures and displays [Drive Status 2] bit pattern at the time of
the last fault.
1 = Condition True
0 = Condition False
Read Only 210
224
thru
230
229 [Alarm 1 @ Fault]
Captures and displays [Drive Alarm 1] at the time of the last
fault.
Notes: Bit 15 was added for firmware revision 2.001. Bits 7, 8,
and 14 were changed to “Reserved” for firmware revision
3.001.
1 = Condition True/Enabled
0 = Condition False/Disabled
Read Only 211
224
thru
230
230 [Alarm 2 @ Fault]
Captures and displays [Drive Alarm 2] at the time of the last
fault.
Note: Bits 14 and 15 were added for firmware revision 2.001.
1 = Condition True
0 = Condition False
Read Only 212
224
thru
230
File
Group
No.
Parameter Name & Description Values
Related
Name
Spd Ref ID 3
Spd Ref ID 2
Spd Ref ID 1
Spd Ref ID 0
Local ID 2
Local ID 1
Local ID 0
At Speed
Faulted
Alarm
Decelerating
Accelerating
Actual Dir
Command Dir
Active
Ready
Default0000000000000000
Bit 1514131211109876543210
Name
Reserved
Reserved
DPI at 500 k
Motor Overld
Bus Freq Reg
Curr Limit
AutoRst Act
AutoRst Ctdn
Reserved
AutoTuning
DC Braking
Stopping
Jogging
Running
Active
Ready
Defaultxx000000x0000000
Bit 1514131211109876543210
Name
Gate Disable
Reserved
Load Loss
Phase Loss
Motor Therm
Waking
Decel Inhibt
Reserved
Reserved
Heatsink Temp
IntDBRes OH
Anlg in Loss
Str At PwrUp
Power Loss
UnderVoltage
Prechrg Actv
Default0x00000xx0000000
Bit 1514131211109876543210
Name
HDW OverTemp
PTC Cflct
TB Ref Cflct
Sleep Config
UserSetCflct
SpdRef Cflct
Reserved
Reserved
VHz NegSlope
MaxFrq Cflct
NP Hz Cflct
MtrTyp Cflct
Bipolr Cflct
DigIn CflctC
DigIn CflctB
DigIn CflctA
Default000000xx00000000
Bit 1514131211109876543210
To Next Page
Loading...
Need help?
General
