3-10 Access Procedures
Removing the 700S Control
Assembly Mounting Plate
Removal
1. Remove power from the drive. Refer to Removing Power from the
Drive on page 3-3.
2. Remove the 700S Phase II Control Assembly. Refer to Removing the
700S Phase II Control Assembly on page 3-6.
3. Remove the 700S High Power Fiber Optic Interface Circuit Board.
Refer to Removing the 700S High Power Fiber Optic Interface Circuit
Board on page 3-8.
4. Lift the Control Assembly mounting plate up and off the hinge.
Installation
Install the 700S Control Assembly mounting plate in reverse order of
removal.
To Next Page
Loading...
