Rockwell Automation Publication 750-PM001N-EN-P - February 2017 9
Preface
Product Safety
Class 1 Light-emitting Diode Product
ATTENTION: An incorrectly applied or installed drive can result in
component damage or a reduction in product life. Wiring or application
errors such as under sizing the motor, incorrect or inadequate AC supply, or
excessive surrounding air temperatures can result in malfunction of the
system.
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive parts
and assemblies. Static control precautions are required when installing,
testing, servicing or repairing this assembly. Component damage can result if
ESD control procedures are not followed. If you are not familiar with static
control procedures, reference Guarding Against Electrostatic Damage,
publication 8000-4.5.2 or any other applicable ESD protection handbook.
ATTENTION: Configuring an analog input for 0…20 mA operation and
driving it from a voltage source could cause component damage. Verify
proper configuration before you apply input signals.
ATTENTION: A contactor or other device that routinely disconnects and
reapplies the AC line to the drive to start and stop the motor can cause drive
hardware damage. The drive is designed to use control input signals that
start and stop the motor. If an input device is used, operation must not
exceed 1 cycle per minute or drive damage can occur.
ATTENTION: Drive must not be installed in an area where the ambient
atmosphere contains volatile or corrosive gas, vapors, or dust. If the drive is
not going to be installed immediately, it must be stored in an area where it is
not exposed to a corrosive atmosphere.
ATTENTION: Hazard of permanent eye damage exists when using optical
transmission equipment. This product emits intense light and invisible
radiation. Do not look into module ports or fiber-optic cable connectors.
To Next Page
Loading...
Need help?
General
