Allen-Bradley Stratix 5400 User Manual

132 Rockwell Automation Publication 1783-UM007G-EN-P - February 2017
Chapter 5 Install Stratix 5700 Switches
Parts List and Required Tools
Verify that you have these items.
The PoE connector ships only with switch models with PoE ports. The
connector is required only if you plan to use PoE.
If needed, an SD card can be ordered separately from the switch.
Obtain these tools:
• Ratcheting torque screwdriver that exerts up to 1.69 N
•m (15 in•lbs) of
pressure
• Small, flat-blade screwdriver
• #6 ring terminal lug for 5.3 mm

(10 AWG) wire, such as Thomas &
Bett part number 10RC6 or equivalent
• Crimping tool, such as Thomas & Bett part number WT2000,
ERG-2001, or equivalent
• 5.3 mm
2
(10 AWG) copper ground wire, such as Belden part number
9912 or equivalent
• Wire-stripping tool
• For panel-mounting without a DIN rail, M5 or #10-24 or #10-32 bolts
or screws with 1.27 cm (0.5 in.) O.D. flat washers
1 Stratix® 5700 switch
2 Documentation
3 PoE connector
4 SD card
At the end of its life, this equipment should be collected separately from any
unsorted municipal waste.
1
2
3
4

Allen-Bradley Stratix 5400 Specifications

General

Model	Stratix 5400
Category	Industrial Ethernet Switch
Layer	Layer 2/3
Management	Web-based, CLI, SNMP
Managed	Yes
Port Types	10/100/1000 Mbps Ethernet
Power over Ethernet (PoE)	Yes
Operating Temperature	-40°C to 70°C (-40°F to 158°F)
Mounting	DIN Rail
Protocols	EtherNet/IP
Security Features	IEEE 802.1X
Power Supply	AC or DC
Redundancy	RSTP
Input Voltage	24 VDC or 100-240 VAC