Drive Motor - Motor Switch
Refer to Internal Wiring of Dryer Motor Switch for wiring schematic.
WARNING
Disconnect electric power to dryer before performing any of the following steps or when replacing inoperative
motor switch.
W290
NOTE: Disconnect terminal 5 wire (yellow or copper) from motor switch before testing start terminals.
NOTE: Reconnect terminal 5 wire (yellow or copper) to motor switch before testing run terminals.
Test Procedures
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
55 Part No. D515519R3
To Next Page
Loading...
Need help?
General