NeXGen Gilbarco/Bennett - Installation and Start Up Guide
Copyright 2018 by Allied Electronics, Inc.
October 18, 2018 Page
1-4
1.6 Overview
The NeXGen controller interfaces to the following devices:
Gilbarco Dispensers & CRINDs
1. Gilbarco dispensers via the 20/30/45 mA current loop & RS485 4-port board,
which is connected to the manufacturer’s Universal Distribution Box.
2. Gilbarco Generic CRINDs Monochrome / Info-Screen Graphics displays and Cash
acceptors via the 20/30/45 mA current loop & RS485 4-port board which is
connected to the Universal Distribution box.
3. GSM (Gilbarco Security Module) is required for CRIND systems with debit
support. The controller communicates to the GSM via an RS-232 port.
Point - Of - Sale (POS)
1. Generic PC based Point -Of -Sale Computer via an RS-232 port or Ethernet port,
supporting the ANDI protocol interface.
OPW OPT and IPT
1. OPW OPT and IPT via an RS485 port. Software Version 18.01A, or newer, must be
installed in the OPT.
Tank gauge
1. Veeder-Root TLS 250, 350 & 350R or equivalent tank gauge system via an RS-
232 port.
2. Any Tank Gauge system that supports the Veeder Root protocol.
Car Wash
1. Ryko III, Ryko IV, Unitec POS 4000, Unitec/Enterlink, Unitec Portal Ti, Unitec Smart
Terminal, PDQ, Kesseltronics and Exacta Car Wash controllers via a fully populated
RS-232 board.
2. Ryko compatible controllers
Fuel Price Sign
1. Daktronics, Future Media, PWM, Skyline, Sunshine Price sign via a fully populated
RS-232 board.
To Next Page
Loading...
Need help?
General