Modifying Advanced Properties
80
ARP Offload
The ARP Offload feature enables the adapter not to wake up when
responding an ARP request. ARP is used to verify whether a computer is
still present on the network and resolute an IP address into a MAC
address.
To enable or disable the ARP Offload feature, do the following:
1. Access the Advanced Properties.
See “Accessing Advanced Properties” on page 76.
2. Select ARP Offload in the Property box.
The ARP Offload page is displayed as shown in Figure 40.
Figure 40. ARP Offload Page
3. Select one of the following options:
Disable — This feature is disabled.
Enable — The adapter does not wake up when responding to an
ARP request. This is the default setting.
4. Click OK.
To Next Page
Loading...
Need help?
General
