Name: Allied Telesis AT-GS950/8
Brand: Allied Telesis
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Chapter 2: Basic Switch Configuration

Note

See Chapter 20, “Simple Network Management Protocol SNMPv1

and v2c” on page 263 and Chapter 21, “Simple Network

Management Protocol SNMPv3” on page 273 to configure the

remaining SNMP parameters.

4. Click Apply located under the Web Server Status Enable/Disable

field.

5. From the main menu on the left side of the page, select Save

Configuration to Flash to permanently save your changes.

User Interface

Timeout

To set the Web Idle Timeout, perform the following procedure:

1. From the main menu on the left side of the page, click the System

folder.

The System folder expands.

2. From the System folder, select User Interface.

The User Interface Page is displayed. See Figure 12 on page 43.

3. Refer to the bottom portion of the web page. Enter the Web Idle

Timeout parameter. The range is from 3 to 60 minutes.

4. From the main menu on the left side of the page, select Save

Configuration to Flash to permanently save your changes.

Other manuals for Allied Telesis AT-GS950/8

Questions and Answers:

Need help?

Do you have a question about the Allied Telesis AT-GS950/8 and is the answer not in the manual?

General