AT-GS950/8 Web Interface User Guide
201
Figure 76. Modify Policy Page
4. Change the parameters as required.
See “Create Policy” on page 198 for the definitions of each
parameters.
5. Click Apply.
The modified Policy entry is displayed in the table at the bottom of the
page of the Create Policy page.
6. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
Delete Policy To delete a Policy entry, perform the following procedure:
1. From the main menu on the left side of the page, select the Access
Control Config folder.
The Access Control Config folder expands.
To Next Page
Loading...
