Allied Telesis XS900MX Series - Figure 60: Returning to the Privileged Exec Mode; Figure 61: Saving the Priority Values with the WRITE Command

Chapter 7: Stacking with the Default Trunk Ports
100
Figure 60. Returning to the Privileged Exec Mode
4. Enter the WRITE command to save your change in the configuration
file. The switch displays the confirmation prompt in Figure 61.
Figure 61. Saving the Priority Values with the WRITE Command
5. To end the management session, enter the EXIT command.
6. Go to Chapter 9, “Cabling the Networking Ports” on page 131, to
continue with the installation.
awplus(config)# exit
awplus#
awplus# write
Building configuration ...
[OK]
awplus#