Allied Telesis XS900MX Series - Powering on a Switch; Figure 46: Plugging in the AC Power Cord; Figure 47: Lowering the Retaining Clip

XS900MX Series Installation Guide for VCStack
83
Powering on a Switch
To power on a switch, perform the following procedure:
1. If you have not installed the power cord retaining clip, go to “Installing
the Power Cord Retaining Clip” on page 54.
2. Connect the power cord to the AC connector on the back panel.
Figure 46. Plugging in the AC Power Cord
3. Lower the retaining clip to secure the power cord to the switch. See
Figure 47.
Figure 47. Lowering the Retaining Clip
4. Connect the power cord to an appropriate AC power source. Refer to
Figure 48 on page 84.