Allied Telesis XS900MX Series - Activating Vcstack; Figure 52: Moving to the Privileged Exec Mode with the ENABLE Command; Figure 53: Moving to the Global Configuration Mode with the CONFIGURE TERMINAL Command; Figure 54: Activating Vcstack with the STACK ENABLE Command

XS900MX Series Installation Guide for VCStack
89
Activating VCStack
If you determined in “Verifying the Status of VCStack” on page 85 that
VCStack is disabled, perform the following procedure to enable it:
1. Start a local management session. Refer to “Starting a Local
Management Session” on page 86.
2. Enter the ENABLE command to move from the User Exec mode to the
Privileged Exec mode, as shown in Figure 52.
Figure 52. Moving to the Privileged Exec Mode with the ENABLE
Command
3. Enter the CONFIGURE TERMINAL command to move to the Global
Configuration mode, as shown in Figure 53.
Figure 53. Moving to the Global Configuration Mode with the CONFIGURE
TERMINAL Command
4. Enter the STACK ENABLE command to activate VCStack on the
switch, as shown in Figure 54 on page 89:
Figure 54. Activating VCStack with the STACK ENABLE Command
5. Enter the EXIT command to return to the Privileged Exec mode, as
shown in Figure 55.
Figure 55. Returning to the Privileged Exec Mode with the EXIT Command
awplus> enable
awplus#
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
awplus(config)#
awplus(config)# stack enable
% The device needs to be restarted for this change to take effect.
awplus(config)#
awplus(config)# exit
awplus#