NeXGen Wayne Direct - Gilbarco / Installation and Start Up Guide
Copyright 2019 by Allied Electronics, Inc.
December 31, 2019 Page
1-3
1.3 Power and Data line protection
Allied Electronics recommends that the controller be installed with the appropriate
power and data line protection devices in order to protect against power surges,
transients, low voltage (brown outs), and lightning.
Note: Due to the magnitude of power that’s contained within a lightning strike it’s
impossible to totally eliminate the possibility of damage, but we feel with the introduction of
high quality protection devices the incidence of failure can be greatly reduced.
1.4 Warranty
The controller has a one year parts warranty only, from date of installation, which can
either be phoned in or submitted using the warranty registration card enclosed with
every controller. If the start up information is not registered with our office within thirty
(30) days of installation, warranty will begin from the date of shipment. Allied will warrant
the controller against defects but not against physical damage or improper installation.
All controllers being returned "under warranty" must be accompanied with an Allied
RMA number. When calling Allied for an RMA number, you will be asked for the
controller serial number, located on the base unit, and a description of the problem.
1.5 FCC Warning
This equipment generates, uses, and can radiate radio frequency energy and if not
installed and used in accordance with the instruction manual, may cause interference to
radio communications. It has been tested and found to comply with the limits for a
Class "A" computing device pursuant to Subpart B of Part 15 of the FCC Rules, which
are designed to provide reasonable protection against such interference when operated
in a commercial environment. Operation of this equipment in a residential area is likely
to cause interference, in which case the user, at his own expense, will be required to
take whatever measures may be required to correct the interference.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
To Next Page
Loading...
Need help?
General
