AlphaTheta DDJ-FLX2 - Utilities Mode Settings

Changing the settings
129
En
Utilities mode settings
You can change the following settings in Utilities mode:
• Back Spin Length
• Fader Start
• Android MONO/STEREO
• Demo mode
 Back Spin Length
When using a jog wheel to perform a Back Spin, you can make the
Back Spin longer or shorter than the amount you rotate the jog wheel
by.
You can set the Back Spin Length to short, normal, or long.
Press one of the Performance Pads 1 through 3 on the right deck.
• Pad 1 is lit: Back Spin Length short
• Pad 2 is lit: Back Spin Length normal (Default)
• Pad 3 is lit: Back Spin Length long
 Fader Start
Press one of the Performance Pads 5 through 7 on the right deck.
• Pad 5 is lit: Fader Start function with the Sync setting is activated.
(When Fader Start starts, the Sync function works at the same time.)
• Pad 6 is lit: Fader Start function without the Sync setting is activated.
(When Fader Start starts, the Sync function doesn't work.)
• Pad 7 is lit: Fader Start function is deactivated.
* When using Serato DJ Lite, even if Pad 5 is lit, Fader Start without
the Sync setting is activated.