2.18 Day-mode and night-mode
This system call number gives the user a possibility of manually selecting day or night mode for all trunk lines. This is
used for incoming calls routing. When a call to a day mode selection is made, all trunk lines will choose the day-mode
routing list, until a call to the nigh-mode selection is performed, hereafter all trunk lines will use the night-mode routing
list.
If a telephone with display is used, a return acknowledge ringing will be made, so the user can see which mode is
selected.
System call numbers are available for 3 purposes:
• Switch to day-mode
• Switch to night-mode
• Check mode
Refer to the AlphaConnect (Classic) Installation Manual for setup of ‘Day-mode and night-mode’ (and system call
number definition).
2.19 Wake-up call
2.19.1 Ordering a wake-up call
The AlphaConnect includes a wake-up call system, where all extensions can order and receive wake-up calls. One-time
and daily wake-up calls can be ordered.
The table below shows the default system call numbers of the wake-up call system and the corresponding effects.
System call number Effect
#111 + 4 digits (HHMM) (00 – 24) (wake-up time) Order a single wake-up call
#112 + 4 digits (HHMM) (00 – 24) (wake-up time) Order a repeated wake-up call (every day, until canceled
by a new wake-up call order)
#110 Cancel an ordered wake-up call
A correctly ordered wake-up call will result in the user hearing the dial tone. Any keying errors will result in no wake-up
call programming (invalid time for example) and the busy tone will be heard.
If repeated wake-up calls have been ordered, the wake-up is re-ordered +24 hours. If a single wake-up call has been
ordered, the wake-up call is just canceled.
2.19.2 Receiving a wake-up call
When the time-of-day equals wake-up time, a call from the system to the extension will be made. The display (if any)
will show “Wake-up call”. If the wake-up is acknowledged by is lifting the handset during the wake-up call, the call will
be terminated. If a wake-up call is not acknowledged in this way, it will be repeated after 5 minutes. This will be done 2
times, after which the wake-up call is terminated.
2.20 Setting system time
The real-time clock of the AlphaConnect system can be adjusted via a call to the ‘set-date-time system’ system call
number. Access to this call is typically restricted to bridge telephones only.
If the time is validated and programmed, a dial tone will be heard. If the time is not validated and thereby not updated, a
busy tone will be heard.
System call number Effect
#120 + 8 digits (YYYYMMDD) Adjust date of AlphaConnect system
#121 + 4 digits (HHMM) (00 – 24) Adjust time of AlphaConnect system
33 | Basic operations and functions
To Next Page
Loading...