4.3.8.15 Date & Time
Adjust the date and time. To be used if the exchange to which the station is connected is not capable of sending data
and time using FSK.
Data format MUST be text string like : YY/MM/DD HH:MM.
Note Settings will be overwritten by any FSK data issued from the telephone exchange and is not preserved
when power is off.
4.3.8.16 Speed Dial
This menu is used to program the F1, F2, and F3 speed dial buttons.
4.3.8.17 Memory Dial
The menu to use when programming the 6 memory dial locations.
Use the ‘F1’-‘F3’ to select M1-M3 / M4-M6 or use
’▲’
or
’▼’
to change to M4-M6 / M1-M3.
4.3.8.18 Dial Signal
Choose loop disconnect dial (pulse dial) or DTMF signaling for dialing numbers to the line.
4.3.8.19 Loop Dial Type
Choose international or Swedish coding of digits for loop dialing numbers to the line.
4.3.8.20 Remote PTT
When this function is enabled, the headset PTT input can be used as a PTT button for using the external speaker as
microphone. Just like for the AlphaConnect P211 communication station
4.3.8.21 Remote Hook Switch
When this function is enabled, the handset hook switch input can be used as a PTT button for using the external speaker
as microphone. Just like for the AlphaConnect P211 communication station.
4.3.8.22 Local External Microphone
Enabling this parameter will change the function of the headset PTT and the headset microphone inputs.
The function is meant to be used on a bridge where the AlphaConnect P411 station cannot be located at the position
where from communication is needed. On that location, a goose neck microphone can be installed – connected to the
headset microphone input - and a push button or foot switch installed -connected to the headset PTT input.
The push button or foot switch is used for accepting incoming calls, just as if pressing the PTT button on the
AlphaConnect P411 itself. If hands free communication is wanted, a short push will turn the AlphaConnect P411 into
hands free.
Obviously calls cannot be made from this position, as this requires dialing at least some digits.
4.3.8.23 Headset microphone type
Select if the headset microphone is an electrets or dynamic type.
4.3.8.24 Headset VOX
This parameter, when set to enable, activates the headset VOX function. This is a voice controlled PTT function on the
headset.
Using the PTT function reduces noise from the station, and reduces the noise heard in own headset ear cups, as the
microphone of the headset is first turned on when speech is detected.
4.3.8.25 Local microphone gain
Enter this menu to adjust the gain of the hands-free microphone.
This is used for adapting to different ambient noise levels, where the gain can be reduced for noisy environments, and
the amplification can be increased where silence is present.
59 | Operation of communication stations
To Next Page
Loading...