CH UNAVAIL
(XM
mode)
• The selected channel
is
not functional. NO USB
UNIT
- Change channels.
1-
----------
-I
• The user has selected a channel number that does not exist or is
not subscribed
to.
- The unit will revert back to the previously selected channel.
• There
is
no artist name/feature, song/program title, or additional
information associated with the channel at that time.
- No action needed.
ERROR
• If an error or other problem occurs.
- Change channels or consult your Alpine dealer.
ERROR
• Communication error
- Turn the ignition key off, and then set to ON again.
ICURRENT ERROR I
• Abnormal current is run to the USB connector device.
-
You
can solve the problem by switching the source, turning the
unit power off, or ACC
to
the OFF position.
DEVICE
ERROR
• A USB device that
is
not supported
by
the unit
is
connected.
- Connect a USB device that is supported
by
the unit.
NO USB
UNIT
• A USB memory
is
not connected.
- Make sure the USB memory device
is
correctly connected and
the cable
is
not excessively bent.
NO FILE
• No song (file) is stored
in
the
USB
memory.
- Connect the
USB
memory device after storing songs (files).
I
UNSUPPORTED
I
• A sampling ratelbit rate not supported
by
the unit
is
used.
- Use a sampling ratelbit rate that
is
supported
by
the unit.
PROTECT
• A copy-protected WMA file was played back.
-
You
can only play back non-copy-protected files.
38-EN
• The iPhone/iPod
is
not connected.
- Make sure the iPhone/iPod
is
correctly connected (refer to
"Connections" on page 43).
Make sure the cable
is
not bent excessively.
NO SONG
• There are no songs in the iPhone/iPod.
- Download songs to the iPhone/iPod and connect to this unit.
ERROR-01 I
• Communication error
- Turn the ignition key off, and then set to ON again.
- Check the display
by
reconnecting between the iPhone/iPod
and this unit, using the iPod cable.
ERROR-02 I
• Caused
by
the iPhone/iPod Software Version not being
compatible with this unit.
- Update the iPhone/iPod Software Version to be compatible
with this unit.
ERROR-03 I
• The iPhone/iPod
is
not verified.
- Change another iPhoneliPod.
I CURRENT ERROR I
• Abnormal current
is
run to the
USB
connector device.
-
You
can solve the problem
by
switching the source, turning the
unit power off, or ACC to the OFF position.
DEVICE ERROR
• A USB device that
is
not supported
by
the unit
is
connected.
- Connect a USB device that is supported
by
the unit.
DC ERROR
• Malfunction occurred
as
a result
of
the speaker cable shorting on
the car chassis.
- Route the cable correctly, and set POWER
IC
to ON (page
17).
If the above solution does not work, consult your nearest
dealer.
To Next Page
Loading...
