54 EAV64301 01/2015
Mounting Conditions
Before You Begin
The metal surfaces of the product may exceed 100 °C (212 °F) during operation.
Attaching A Label With Safety Instructions
DANGER
ELECTRIC SHOCK CAUSED BY FOREIGN OBJECTS OR DAMAGE
Conductive foreign objects in the product or damage may cause parasitic voltage.
z Do not use damaged products.
z Keep foreign objects such as chips, screws or wire clippings from getting into the product.
Failure to follow these instructions will result in death or serious injury.
WARNING
HOT SURFACES
z Ensure that any contact with hot surfaces is avoided.
z Do not allow flammable or heat-sensitive parts in the immediate vicinity of hot surfaces.
z Verify that the heat dissipation is sufficient by performing a test run under maximum load conditions.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
Step Action
1 Select the label suitable for the target country
2 Observe the safety regulations in the target country
3 Attach the label to the front of the device so that it is clearly visible
To Next Page
Loading...
