O & C M A N U A L • 1 2 0 0 - T H / I I I M AR I N E
P G . 26
S E R V I C E
T R O U B L E S H O O T I N G
Error Possible Cause
Code Description/Results Service Required
E-10 Air Sensor Fault (shorted)
Air sensor defective? See following page for air sensor test.
E-11 Air Sensor Fault (open)
E-20 Product Probe Fault (shorted)
Probe defective? See following page for probe sensor test.
E-21 Product Probe Fault (open)
E-30 Under temperature Oven door closed? Door gasket need replacement? Preheat skipped?
Oven overloaded or has frozen product? Defective air sensor or probe?
Defective solid state relay? Bad wire connections or open heating cable?
Is the high limit switch tripped? If none of the above, call service.
E-31 Over temperature Shorted cable? Defective solid state relay? Defective air sensor?
If none of the above, call service.
E-60 Real time clock error Control must be replaced.
NOTE: If the appliance has been unplugged for an extended period of
time, the Real Time Clock may require recharging. Plug the unit into
the proper receptacle for a minimum of 24 hours.
E-70 Configuration connector error Check control connections for loose wires.
If none, control must be replaced.
E-78 Voltage low If 125 VAC unit, voltage is below 90 VAC. Correct.
If 208-240 VAC voltage is below 190 VAC. Correct.
E-79 Voltage high If 125 VAC unit, voltage is over 130 VAC. Correct.
If 208-240 VAC, voltage is over 250 VAC. Correct.
E-80 EEPROM - Function data error Replace control.
E-82 EEPROM - Calibration data error Replace control.
E-84 EEPROM - Unit ID error Replace control.
E-86 EEPROM - Preset data error Replace control.
Ino p e rativ e Ove n
Ino p e rativ e Ove n
Ove n w ill co o k in tim e o nly
Ove n w ill co o k in tim e o nly
Oven will not reach set tem perature
Ove n w ill sh ut d o w n
Ino p e rativ e Ove n
Ino p e rativ e Ove n
Ino p e rativ e Ove n
Ino p e rativ e Ove n
Ino p e rativ e Ove n
Ino p e rativ e Ove n
Ino p e rativ e Ove n
Ino p e rativ e Ove n
To Next Page
Loading...
