COMBITHERM INSTALLATION AND MAINTENANCE MANUAL #6004/18
PG. 9
COMBITHERM® ELECTRONIC CONTROL OPERATION
Fahrenheit or Celsius Selection
Turn Power Switch "OFF" and wait a minimum of two minutes.
After two minutes, press the Temp Key, the Timer Key, and the
Start/Stop Key at
the same time.
While pressing the three keys, turn the Power Switch to the Full Speed
position.
Release the three keys. The main display will indicate a service
program number such as
"S1."
Press the Up and Down Arrow Keys to change the service program
number to
"S2."
Press the Start/Stop Key when "S2" appears in the Main Display.
Press the Up and Down Arrow Keys to select 0 (CELSIUS) or 1
(FAHRENHEIT).
Press the Start/Stop Key to confirm the temperature scale selection.
The control is now set to operate in the temperature scale selected.
Note: Do not choose or change any service program other than "S2."
Changing any other factory setting could adversely affect oven performance.
Oven Start Up
Always begin daily operation of the combitherm with a clean oven.
Turn Power Switch "ON" to desired position — full fan speed or
half fan speed. Buzzer will sound.
Press Steam Program Key.
Water needed light flashes until steam generator is filled.
Steam LED light will flash until the water temperature has reached the
stand-by mode temperature of 150°F (65°C). When the light stops
flashing, the oven is ready to operate.
Cooking Programs
Standard cooking programs are steam, superheated steam and convection,
convection, Bio steam (optional) and retherm (optional).
Steam Program (212°F/100°C)
Press Steam Program Key and indicator light will appear.
Press Time Key. The main display will indicate last set time.
To reset the time from the previous operation, press the Up and Down
Arrow Keys to change the value shown in the display
(1 to 199 minutes).
Press the Start Key. The Fan LED will be illuminated throughout the
entire cooking process. The Steam indicator light will illuminate
periodically whenever the oven is producing steam. The Main display
will indicate time remaining. A buzzer will sound for one minute
signaling the end of the program.
Note: The buzzer can be turned off
immediately by pressing any program key.
To Next Page
Loading...
Need help?
General